![]() ![]() I admit I have not had time to try the proposed solution, I will try this later this week. PS : I saw a few posts mentioning something about a non-standard TCP/IP implementation from Netgear. MODEM: Fail to open serial port /dev/cuau0 on speed 115200Īnyone with experience with Netgear LB2120 can help and share their config with me please ?Ĭould it be that I should be using another Link Interface ? I am not sure how this works to be honest. Link: reconnection attempt 1 in 1 seconds I'm running OPNsense21.7.7-amd64 and FreeBSD12.1-RELEASE-p19-HBSDĭespite all this, I am getting errors in the logsĬHAT: The modem is not responding to "AT" at ModemCmd: label. I selected the only Link Interface prompting on the screen /dev/cuaU0 > Create Point-to-Point device in Opnsense in PPP with parameters similar to that found on the LB2120. The IDG400 is multi carrier capable it works on ATT, T-Mobile, or Verizon (US only) and will associate with a network based on the SIM card that is inserted. ![]() > Setup Netgear LB2120 in bridge mode with ethernet on WAN port The Protectli IDG400 is a 4G LTE modem that can be added to the Vault to enable 4G LTE data as a primary internet connection or for backup. > Full setup and update of Opnsense (Protectli box) After browsing these forums and that from PFsense I bought a Netgear LB2120 modem which seemed to be compatible out of the box. I use a 4G SIM as my main network connection. New with Opnsense - switching from Ubiquiti. ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |